Timeout For Manual Feeding - Fujitsu fi-5950 Operator's Manual

8.25 Timeout for Manual Feeding

In manual feeding mode, if the scanner is left without loading the next document to scan for an extended
time period, the scanner completes the scanning once and cancel the manual feeding mode. The time
period is called "timeout".
Configure the settings for the Timeout for Manual as follows:
1. Start up the Software Operation Panel.
Refer to
"8.1 Scanner Settings" on page 173
2. Select [Device Setting 2] from left side list in the window, and select
[Timeout for manual feeding] from its lower level.
3. Select the timeout period for manual feeding.
You can specify the timeout period by seconds. Scanning will be complete when the specified
time period has elapsed after the last sheet of paper was loaded onto the Hopper.
Select a timeout period from the following:
5, 10, 20, 30, 40, 50, 60, 70, 80, 90, 100, 110, 120, 180, 240, 300, 360, 420, 480, 540, 600, 900,
1200, 1800, 1999 (seconds)
HINT
For details on how to scan the document manually, refer to
Documents Manually" on page
.
36.

8.25 Timeout for Manual Feeding

8
"2.12 Feeding
217