Device Setting - Fujitsu fi-5950 Operator's Manual

■ Settings
Using the Software Operation Panel, you can configure the following settings for the scanner connected to the PC.
ATTENTION
［Device setting］
Item
Page Counter
For evaluating the consumable replace-
(Consumables
ment cycle or cleaning cycle.
counter)
Use this function to reset the counters
after replacing consumables or the
cleaning.
Refer to
Replacement Cycle" on page
Power saving Select the waiting time before entering
the Power saving mode.
Refer to
on page
Offset setting Adjust the start position for the docu-
ment scanning.
Refer to
page
Vertical magnifi-
Adjust the magnification in the feed-
cation Adjustment
ing direction.
Refer to
page
182
8.1 Scanner Settings
In View Only mode, the Software Operation Panel cannot be set. For
details on "View Only mode", refer to
Explanation
"5.1 Consumables and
120.
"8.2 Power saving setting"
187.
"8.3 Offset/Scan scale" on
188.
"8.3 Offset/Scan scale" on
188.
"Password Setting" on page 175
Selectable parameter
After Cleaning/Pad/Pick roller/Sepa-
rator Roller/Brake roller/Remaining
ink level (only for the imprinter
option)
Setting range 15 to 55 minutes (set in
steps of 5 min.)
Left right: setting range -2 to 3mm
(set in 0.5mm steps)
Up down: setting range -2 to 3mm (set
in steps of 0.5mm)
Setting range -6.3% to 6.3% (set in
0.1% steps)
Default
-
15 min.
left right
0mm
up down
0mm
0%