Paper Stop Position At Multifeed Error - Fujitsu fi-5950 Operator's Manual

8.27 Paper Stop Position at Multifeed
Error
When a multifeed error is detected by overlapping of documents, the position to stop the documents on
which the multifeed occurred can be selected.
To configure this setting, [Check by overlapping (US sensor)] must be specified for multifeed detection
(
"8.4 Multifeed Detection" on page 190
Configure the settings for Paper Stop Position at Multifeed Error as follows.
1. Start up the Software Operation Panel.
Refer to
"8.1 Scanner Settings" on page 173
2. Select [Device Setting 2] from left side list in the window, and select
[Paper stop position at multifeed error] from its lower level.
3. Select one of the following modes and click the [OK] button.
Normal
Paper output slot
).
.
: Stops feeding when a multifeed error is detected by overlapping.
: Feeds the documents to the Paper output slot and stops when a multi-
feed error is detected by overlapping.
This setting makes it easier to identify on which document a multifeed
error occurred.

8.27 Paper Stop Position at Multifeed Error

8
219