Denon D-107 Operating Instructions Manual page 7

Connecting a CD receiver and subwoofer
About mounting the main unit stand
2
You will need a screwdriver to assemble.
q Connect the system cable to the bottom of
the main unit.
Top
[Connector]
Press Press
Connect with the driver
part of the system cable's
connector facing upwards.
w Run the system cable around to the back, line up the positioning pin
of the included main unit stand with the hole in the
main unit, then mount with the included screws.
Positioning pin hole
e Connect the plug on the opposite side of the system cable to the subwoofer.
SYSTEM
CONNECTOR
SPEAKER SYSTEM
IMPEDANCE:6 16
R L
About mounting the cable cover [When mounting on the wall] (See page 8.)
2
Run the system cable around to the back, line up the
positioning pin of the included cable cover with the hole
in the main unit, then mount with the included screws.
Positioning pin
Positioning pin hole
Insert the plug securely, pressing
it in all the way it will go.
Front
Positioning pin
Connect with the wider part of the system cable's
connector facing upwards.
Insert the plug securely, pressing it in all the way it
will go.
Front
Connecting the speakers
About mounting the speaker stand
2
Paying attention to set the included
speaker stand in the proper front/back
Positioning pin
position, line up the positioning pin with
the hole in the speaker, then mount it
with the included screws and fasten it
securely.
2 Connecting the speakers and cords
• Use the included speaker cords to connect the speakers and subwoofer.
• Connect the left channel speaker (the left side as soon from the front) to the "L" terminals, the right
channel speaker to the "R" terminals.
q Lower the lever. w Insert the speaker cord.
Connect the cord's copper-colored core wire to the
"+" side, the silver-colored core wire to the " " side.
Core wire
(copper-colored)
Push down Core wire
(silver-colored)
and insert the
speaker cord.
NOTES:
• Be sure to unplug the power supply cord before
connecting the speakers.
• Be sure to connect the speaker cords properly (+
to +, to , L to L and R to R).
• Do not short-circuit the speaker cords.
If the power is turned on, accidentally short-
circuiting the speaker cords could cause damage
or accidents.
• Be sure to connect the speaker to the speaker
terminals with the proper polarities (+ to +,
to ).
If the polarities are wrong, the sound from the
center will be weak, the positioning of the
ENGLISH
Positioning
Front
pin hole
e Return the lever.
Core wire
(copper-colored)
Core wire (silver-colored)
• Gently pull the cord to check that
it is securely connected.
SPEAKER SYSTEM
IMPEDANCE:6 16
R L
instruments will be unclear and the stereo effect
will be poor.
• Never play such special signals as sine waves or
the fast-forwarding signals of a tape recorder
continuously.
SPEAKER SYSTEM SPEAKER SYSTEM
IMPEDANCE:6 16 IMPEDANCE:6 16
R L R L
7