Route - Ricoh Aficio SP W2470 Software Manual

route

Use the "route" command to view and control the routing table.
❖ All route information display
msh> route get "destination"
• Specify the IPv4 address to destination.
"0.0.0.0" cannot be specified as destination address.
• If you do not specify a destination address, all the information about the
router is displayed.
❖ Enabling/disabling Specified IPv4 Destination
msh> route active {host|net} "destination" {on | off}
• You can turn the specified destination on or off. Host becomes the default
setting.
❖ Adding IPv4 Routing Table
msh> route add {host|net} "destination" "gateway"
• Adds a host or network route to "destination", and a gateway address to
"gateway" in the table.
• Specify the IPv4 address to destination and gateway.
• Host becomes the default setting.
❖ Setting Default IPv4 Gateway
msh> route add default gateway
❖ Deleting specified IPv4 destination from Routing Table
msh> route delete {host|net} "destination"
• Host becomes the default setting.
• IPv4 address of destination can be specified.
❖ Setting IPv6 Default Gateway
msh> route add6 default "gateway"
❖ Adding a specified IPv6 destination to Routing Table
msh> route add6 "destination" "prefixlen" "gateway"
• Specify the IPv6 address to destination and gateway.
❖ Deleting a specified IPv6 destination from Routing Table
msh> route delete6 "destination" "prefixlen"
• Specify the IPv6 address to destination and gateway.
Remote Maintenance by telnet
6
235