Connections; Connecting Audio Components - Denon AVR-3300 Operating Instructions Manual

5 CONNECTIONS

• Do not plug in the AC cord until all connections have been completed.
• Be sure to connect the left and right channels properly (left with left, right
with right).
• Insert the plugs securely. Incomplete connections will result in the
generation of noise.
• Use the AC OUTLETS for audio equipment only. Do not use them for
hair driers, etc.
Connecting the audio components
• When making connections, also refer to the operating instructions of the other
components.
The power to these outlets is turned on and off when the power is switched between on
and standby from the remote control unit or power switch.
OUTPUT
R L
CD player
DIGITAL AUDIO DIGITAL AUDIO
R L
Connecting a turntable
Connect the turntable's output cord to the AVR-
3300's PHONO jacks, the L (left) plug to the L jack,
the R (right) plug to the right jack.
NOTE:
This unit cannot be used with MC cartridges
directly. Use a separate head amplifier or step-up
transformer.
If humming or other noise is generated
when the ground wire is connected,
disconnect the ground wire.
Turntable
(MM cartridge)
Ground
wire
MD recorder, DAT deck or other component
equipped with digital output jacks
OUTPUT
OPTICAL
DIGITAL AUDIO DIGITAL AUDIO
OPTICAL COAXIAL
OUTPUT
Connecting the DIGITAL jacks
Use these for connections to audio equipment with digital output. Refer to page 25 for
instructions on setting this terminal.
NOTES:
• Use 75 Ω/ohms cable pin cords for coaxial connections.
• Use optical cables for optical connections, removing the cap before connecting.
Connecting a CD player
Connect the CD player's analog output
jacks (ANALOG OUTPUT) to this unit's CD
jacks using pin plug cords.
Connecting the pre-out jacks
Use these jacks if you wish to connect external power amplifier(s) to
increase the power of the front, center and surround sound channels, or for
connection to powered loudspeakers.
FREQ. STEP EXT. IN R L
IN
9kHz
FR FL DVD
10kHz
LOOP
ANT.
SW C VDP
AM
TV/
SR SL
DBS
FM ER R L EL VCR-1
L
COAX.
75
ANTENNA VCR-2/
R
CD
V.AUX
SIGNAL
GND R L L
MD/
PHONO
TAPE
R
IN
OPT.-1 VCR-1
VCR-2/
OPT.-2
V.AUX
COAXIAL
MD/
OPT.-3
TAPE
OUT
R L MONITOR
R L
DIGITAL AUDIO C-VIDEO S-VIDEO
CD player or other
component equipped
with digital output jacks
• Note that binding pin plug cords together with AC cords or placing them
near a power transformer will result in generating hum or other noise.
• Noise or humming may be generated if a connected audio equipment is
used independently without turning the power of this unit on. If this
happens, turn on the power of the this unit.
AC OUTLETS
• SWITCHED
(total capacity – 120 W (1 A.) – for North America model)
(total capacity – 100 W – for multiple voltage model)
The power to these outlets is turned on and off in conjunction with the
POWER operation switch on the main unit, and when the power is switched
between on and standby from the remote control unit. (Multiple voltage
model only)
No power is supplied from these outlets when this unit's power is at standby.
Never connect equipment whose total capacity is above 120 W (1 A.) for
North America model (100 W for multiple voltage model).
NOTE:
Only use the AC OUTLETS for audio equipment. Never use them for hair
driers, TVs or other electrical appliances.
SAME AS LINE-VOLTAGE
SWITCHED 100W MAX.
AC OUTLET
for Multiple voltage model
COMPONENT VIDEO
Y C B C R Y C B C R
IN DVD IN TV/DBS
L
R
MULTI/
EFFECT SURROUND
PRE OUT
FRONT CENTER
R L
SPEAKER SYSTEMS
VOLTAGE SELECTOR
For multiple voltage
model only
(Refer to page 5.)
Route the connection cords, etc., in such a way
that they do not obstruct the ventilation holes.
R L R L
Tape deck or MD recorder
R L R L
INPUT OUTPUT
Connecting a tape deck
Connections for recording:
Connect the tape deck's recording input jacks (LINE IN or REC) to this unit's tape
recording (MD/TAPE OUT) jacks using pin plug cords.
Connections for playback:
Connect the tape deck's playback output jacks (LINE OUT or PB) to this unit's tape
playback (MD/TAPE IN) jacks using pin plug cords.
Connecting the AC OUTLTETS
SWITCHED
TOTAL 120W(1A.)MAX.
AC 120V 60HZ
AC OUTLETS
for North America model
Y C B C R
OUT MONITOR
CENTER VOLTAGE SELECTOR
115V 230V
L
R
SUB
WOOFER FRONT
SAME AS LINE-VOLTAGE
SURROUND SURROUND
SWITCHED 100W MAX.
B A
R L R L AC OUTLET
AC CORD
AC 120 V, 60 Hz
(North America model)
AC 115/230 V, 50/60 Hz
(Multiple voltage model)
ENGLISH
7