Table of Contents
Advertisement
8 REMOTE CONTROL UNIT
• The included remote control unit (RC-860) can be used to operate not only the AVR-3300 but other remote control compatible DENON
components as well. Furthermore, it is equipped with a function for learning the control signals of remote control units of other manufacturers,
so it can also be used to operate non-DENON remote control compatible video components.
Inserting the batteries
q Remove the remote control unit's rear cover.
w Set two R6P/AA batteries in the battery compartment in the
indicated direction.
e Put the rear cover back on.
Using the remote control unit
B
Approx. 7 m/22 feet
Notes on Batteries
• Use R6P/AA batteries in the remote control unit.
• The batteries should be replaced with new ones approximately
• Even if less than a year has passed, replace the batteries with new
• When inserting the batteries, be sure to do so in the proper
• To prevent damage or leakage of battery fluid:
• Remove the batteries from the remote control unit when you do
• If the battery fluid should leak, carefully wipe the fluid off the inside
• When replacing the batteries, have the new batteries ready and
• The learned remote control signals may be cleared if no batteries
• Point the remote control unit at the remote sensor on the main unit
• The remote control unit can be used from a straight distance of
• The remote control unit can be operated at a horizontal angle of up
NOTES:
• It may be difficult to operate the remote control unit if the remote
• Do not press buttons on the main unit and remote control unit
30°
30°
• Neon signs or other devices emitting pulse-type noise nearby may
once a year, though this depends on the frequency of usage.
ones if the set does not operate even when the remote control unit
is operated nearby the set.
direction, following the "≈" and "√" marks in the battery
compartment.
• Do not use a new battery together with an old one.
• Do not use two different types of batteries.
• Do not short-circuit, disassemble, heat or dispose of batteries in
flames.
not plan to use it for an extended period of time.
of the battery compartment and insert new batteries.
insert them as quickly as possible.
are in the remote control unit for about 5 seconds.
The factory-installed codes are in permanent memory, however.
as shown on the diagram.
approximately 7 meters/22 feet from the main unit, but this
distance will be shorter if there are obstacles in the way or if the
remote control unit is not pointed directly at the remote sensor.
to 30 degrees with respect to the remote sensor.
sensor is exposed to direct sunlight or strong artificial light.
simultaneously. Doing so may result in malfunction.
result in malfunction, so keep the set as far away from such
devices as possible.
ENGLISH
29
Hide quick links:
Advertisement
Table of Contents
