Table of Contents
Advertisement
Lexicon Studio 12T System User Guide for Macintosh and PC
7. If you want the signal to be sent to the effects before the faders, click on the Pre button for the
send.
8. With Pre-fader effect sends, the amount of effect for the channel is not affected by the volume
fader. With Post-fader effect sends (Pre button not pressed), the amount of effect is proportional
to the channel volume, and will change with the volume fader movements.
The next step is to select programs and set the parameters for the effect processors. As you will
probably need to adjust the send levels while doing this, leave the EQ window open.
Selecting PC-90 and Making Settings
Effect types and programs are selected in the Effects window:
1. Pull down the Audio menu and select Effects. This window resembles an effects rack, with
stacked processors.
2. Activate an effects processor by clicking on its Power button.
3. Verify that the effect output is routed to the desired source, in the bus pop-up in the lower right
corner. The default setting for this is Master.
Using the PC-90
51
Advertisement
Table of Contents
