Table of Contents
Advertisement
Installation
Hardware Installation
As some Lexicon Studio software is installed into directories of your audio control software (such as
Cubase Audio VST), you should install and verify that your audio software launches properly before
installing Lexicon Studio (even though it will not be audio-capable until installation of the Lexicon
Studio system). Please refer to your audio software manual for details on installation, and then
proceed with Lexicon Studio hardware and software installation.
Setup
1. Put on the anti-static wrist strap.
2. Place the foam from your Lexicon Studio package on top of a work surface next to your computer.
(Any flat piece of static-safe foam with similar dimensions to the Core-32 card can be used.)
3. Make sure that you computer is properly shut down and unplugged.
4. Remove the computer top cover and PCI slot cover(s) for the slots you've chosen for your Lexicon
Studio cards. If you do not know how to open your computer, consult the manufacturer's owner's
manual.
5. Touch the computer power supply case to discharge any personal static electricity.
6. Remove the Core-32 from its anti-static bag, holding the card only by its edges. Be careful to avoid
touching the pins on the bottom edge of the card. Place the Core-32 bag on top of the foam and
place the card on the foam with the white PC-90 connector facing up.
6
Lexicon
Advertisement
Table of Contents
