Cw Delay Time Setting - Yaesu FT DX 9000 CONTEST Operation Manual

CW C CW C CW C
CW C CW C
ONVENIENCE ONVENIENCE ONVENIENCE
ONVENIENCE ONVENIENCE
During semi-break-in (not QSK) operation, the hang time of the transmitter, after you have finished sending, may be
adjusted to a comfortable value consistent with your sending speed. This is the functional equivalent to the "VOX Delay"
adjustment used on voice modes; however, this is an independent adjustment used on CW, so you don't have to change the
delay when changing from Voice to CW.
The delay may be varied anywhere between 0 seconds ( [ CW DELAY ] knob set fully counter-clockwise) to 5 seconds
(fully clockwise).
[ CW DELAY ] Knob
[ BK-IN/SPOT ] Switch
1. Press the [ BK-IN/SPOT ] key momentarily to enable
CW transmission (Menu item "MODE-CW 055 CW
BK-IN" must be set to "SEMI").
2. Start sending, and adjust the [ CW DELAY ] knob so
that the hang time is as you prefer for comfortable
operation.
A
DVICE
The VFO-B frequency display will show the hang
time of the CW "VOX" circuit for 3 seconds when-
ever the [ CW DELAY ] knob is turned.
You may disable this feature (displaying the hang
time of the CW "VOX" circuit) via Menu item
"DISPLAY 022 LEVEL INDICATOR." See page
133 for details.
Page 98
F F F F F
EA EA EA EA EA TURES TURES TURES TURES
TURES
CW D T
ELAY
S
IME ETTING
Q
UICK
The CW Delay feature is the functional equivalent
to the "VOX Delay" adjustment used on voice
modes; however, this is an independent adjustment
used on CW, so you don't have to change the delay
when changing from Voice to CW.
FT 9000 C
DX ONTEST
VDD BIAS TEMP SWR
P
OINT
O M
PERATION ANUAL