Audio Peak Filter; Cw Delay Time Setting; Cw Pitch Adjustment - Yaesu FT-2000 Operating Manual

1. Press the [ CONT ] button to disable the Contour filter,
if necessary. The Contour indicator disappear from the
CONTOUR indication on the display.
2 Press and hold the [ CONT ] button for 2 seconds to
activate the APF (Audio Peak Filter) which provides a
very narrow audio bandwidth.
A :
DVICE
When APF is engaged, the peak position of the APF is
depicted graphically in the CONTOUR indicator (but,
" " icon does not appear).
Disappears
Peak Position of the APF
3. To disable the APF, press and hold the [ CONT ] button
for 2 seconds again.
During semi-break-in (not QSK) operation, the hang time of the transmitter, after you have finished sending, may be
adjusted to a comfortable value consistent with your sending speed. This is the functional equivalent to the "VOX Delay"
adjustment used on voice modes, and the delay may be varied anywhere between 20 milli-seconds ( [ DELAY ] knob set fully
counter-clockwise) and 5 seconds (fully clockwise).
1. Press the [ BK-IN ] button to enable CW transmission
(Menu item "060 A1A BK-IN" must be set to "SEni").
2. Start sending, and adjust the [ DELAY ] knob so that
the hang time is as you prefer for comfortable opera-
tion.
A :
DVICE
The Sub band (VFO-B) frequency display will show the
spot tone frequency for 3 seconds whenever the [ DELAY ]
knob is turned.
You may disable this feature (displaying the spot tone fre-
quency) via Menu item "015 diSP LVL IND." See page
113 for details.
Rotation of the front panel's [ PITCH ] knob will allow
adjustment of the center frequency of the receiver pass-
band, as well as the pitch of your offset CW carrier, to the
tone you prefer. The tone may be varied between 300 Hz
and 1050 Hz, in 50 Hz steps.
A :
DVICE
The Sub band (VFO-B) frequency display will show the
spot tone frequency for 3 seconds whenever the [ PITCH ]
knob is turned.
You may disable this feature (displaying the spot tone fre-
quency) via Menu item "015 diSP LVL IND." See page
113 for details.
T :
ERMINOLOGY
CW Pitch: If you tuned to an exact "zero beat" on an incoming CW signal, you could not copy it ("Zero beat" implies a 0
Hz tone). Therefore, the receiver is offset several hundreds of Hz (typically), so as to allow your ear to detect the tone. The
BFO offset associated with this tuning (that produces the comfortable audio tone) is called the CW Pitch.
FT-2000 O
PERATING
CW C
A
UDIO
CW D
ELAY
CW P
ITCH
M
ANUAL
ONVENIENCE
P F
EAK ILTER
CONTOUR Indicator
T S
IME ETTING
[ BK-IN ] Button
[ DELAY ] Knob
A
DJUSTMENT
[ PITCH ] Knob
[ SPOT ] Button
F
EATURES
[ CONT ] Button
Sub ( VFO-B ) frequency display
Page 83