Yaesu FT DX 9000 CONTEST Operation Manual page 105

Text Message Programming
1. Press the [ CW ] Mode key to set the operating mode to
CW.
2. Be sure that Break-in is Off by pressing the [ BK-IN/
SPOT ] key, if necessary.
3. Press the FH-2's [ MEM ] key.
ON
4. Press the FH-2's [ 1 ] ~ [ 5 ] key to select the desired
Message Memory Register into which you wish to pro-
gram the text.
ON
5. Use the FH-2's [ ] and [ ] keys to set the cursor
position and use the [ ] and [ ] keys to choose the
letter/number to be programmed in each slot of the
memory. In the case of the second example above, the
" } " character designates the slot where the Contest
Number will appear.
A
DVICE
You may also use the [ Main Tuning Dial ] knob and
the [ CLAR/VFO-B ] knobs to program the message
characters.
ON
6. Press the FH-2's [ MEM ] key again once all characters
have been programmed.
FT 9000 C O
DX ONTEST
C M
ONTEST
LOCK
OFF
LOCK
OFF
LOCK
OFF
M
PERATION ANUAL
CW C CW C CW C
CW C CW C
ONVENIENCE ONVENIENCE ONVENIENCE
ONVENIENCE ONVENIENCE
K
EMORY EYER
Checking the CW Memory Contents
1. Be sure that Break-in is still turned Off.
2. Press the FH-2's [ 1 ] ~ [ 5 ] key to check your work.
You will hear the results in the sidetone, but no RF
energy will be transmitted.
On-The-Air CW Message Playback
1. Press the [ BK-IN/SPOT ] key to enable transmission.
Either Full- or Semi-break-in will be engaged, depend-
ing on the setting of Menu item "MODE-CW 055 CW
BK-IN."
2. Press the FH-2's [ 1 ] ~ [ 5 ] key to transmit the pro-
grammed message.
N
OTE
If you subsequently decide to use the "Message" tech-
nique for memory storage, please note that the con-
tents of a message stored using text input will not be
transferred over when you select "MESSAGE" on a
particular memory register.
Correcting/Editing
Previously-Stored Characters
Use the [ Main Tuning Dial ] knob to select the
letter/number to be corrected, then rotate the
[ CLAR/VFO-B ] knob to choose the revised let-
ter/number top be utilized in this slot.
Deleting Previously-stored Characters
Use the [ Main Tuning Dial ] knob to select the
last correct letter in the message. Now rotate the
[ CLAR/VFO-B ] knob to select the " } " character;
everything after the " } " character will be deleted.
F F F F F
EA EA EA EA EA TURES TURES TURES TURES
TURES
LOCK
ON OFF
LOCK
ON OFF
Page 103