Memory Operation; Memory Storage - Yaesu FT DX 9000 CONTEST Operation Manual

M M M M M O O O O O
EMOR Y Y Y Y Y EMOR EMOR PERA PERA PERA TION TION TION TION
EMOR EMOR PERA PERA TION
The memory system of the FT
mode, and a wide variety of status information detailed previously. Memories may be grouped into as many as six Memory
Groups, and additionally you get nine pairs of band-limit (PMS) memories along with five QMB (Quick Memory Bank)
memories.
1. Set the VFO-A up with all frequency, mode, and sta-
tus the way you want to have it stored.
2. Press the [ A M ] button momentarily (the current
channel number will start blinking); the contents of
the current memory channel will be shown on the VFO-
B display field.
3. Press the [ MCH/GRP ] key momentarily.
When you press the [ MCH/GRP ] key, the Red LED
imbedded within the switch should light up, indicat-
ing that you are ready to choose a channel into which
to store the data.
A
DVICE
If the Red LED imbedded in the [ MCH/GRP ] switch
does not light up, check to be sure that the orange lamp
to the right of the [ CLAR/VFO-B ] knob is not illumi-
nated. It is, press the [ A/B ] switch to make it go out,
then press the [ MCH/GRP ] key again.
Page 110
9000 Contest allows storage and recall of up to 99 memories, each storing frequency,
DX
M
EMORY
S
TORAGE
[ A M ] Switch
4. Rotate the [ CLAR/VFO-B ] knob to select the memory
channel onto which you wish to store the data. If you
have selected a channel on which data is already stored,
that frequency will appear on the VFO-B's frequency
display field.
5. Press and hold in the [ A M ] key for two seconds to
store the frequency and other data into the selected
memory channel. A double beep will confirm that you
have held the [ A M ] key in long enough.
FT 9000 C
DX ONTEST
[ CLAR/VFO-B ] Switch
VDD BIAS TEMP SWR
[ MCH/GRP ] Switch
[ A/B ] Switch
O M
PERATION ANUAL