Cw Delay Time Setting; Cw Pitch Adjustment - Yaesu FT-2000 Operating Manual

During semi-break-in (not QSK) operation, the hang time of the transmitter, after you have finished sending, may be
adjusted to a comfortable value consistent with your sending speed. This is the functional equivalent to the "VOX Delay"
adjustment used on voice modes, and the delay may be varied anywhere between 20 milli-seconds ( [ DELAY ] knob set fully
counter-clockwise) and 5 seconds (fully clockwise).
1. Press the [ BK-IN ] button to enable CW transmission
(Menu item "058 A1A BK-IN 058 A1A BK-IN" must be set to "SEni
058 A1A BK-IN 058 A1A BK-IN
058 A1A BK-IN
2. Start sending, and adjust the [ DELAY ] knob so that
the hang time is as you prefer for comfortable opera-
tion.
Rotation of the front panel's [ PITCH ] knob will allow
adjustment of the center frequency of the receiver pass-
band, as well as the pitch of your offset CW carrier, to the
tone you prefer. The tone may be varied between 300 Hz
and 1050 Hz, in 50 Hz steps.
A :
DVICE
You may confirm the Spot tone frequency when turning
the [ PITCH ] knob while pressing the [ SPOT ] button. Sub
(VFO-B) frequency display will shows the Spot tone fre-
quency.
T :
ERMINOLOGY
CW Pitch: If you tuned to an exact "zero beat" on an
incoming CW signal, you could not copy it ("Zero beat"
implies a 0 Hz tone). Therefore, the receiver is offset sev-
eral hundreds of Hz (typically), so as to allow your ear to
detect the tone. The BFO offset associated with this tun-
ing (that produces the comfortable audio tone) is called
the CW Pitch.
FT-2000 O
PERATING
CW C
CW D
ELAY
SEni SEni
SEni"). SEni
CW P
ITCH
M
ANUAL
ONVENIENCE
T S
IME ETTING
[ BK-IN ] Button
[ DELAY ] Knob
A
DJUSTMENT
[ PITCH ] Knob
[ SPOT ] Button
F
EATURES
Sub ( VFO-B ) frequency display
Page 83