NETGEAR DGN2200-100NAS User Manual page 88

Note: If you configure the wireless-N modem router from a wireless computer, add
your computer's MAC address to the access list. Otherwise you will lose your
wireless connection when you click Apply. You must then access the wireless-
N modem router from a wired computer, or from a wireless computer that is
on the access control list, to make any further changes.
2. In the Wireless Settings screen, under the Wireless Station Access List section, click the Setup
Access List button to display the list.
Figure 6-9
3. Select the Turn Access Control On check box to enable the restricting of wireless computers
by their MAC addresses.
4. If the wireless station is currently connected to the network, you can select it from the
Available Wireless Stations list. Click Add to add the station to the Trusted Wireless Stations
list.
5. If the wireless station is not currently connected, you can enter its address manually. Enter the
MAC address of the authorized computer. The MAC address is usually printed on the wireless
card, or it might appear in the wireless-N modem router's DHCP table. The MAC address is
12 hexadecimal digits.
Click Add to add your entry. You can add several stations to the list. When you are finished
adding stations, click Apply.
Note: You can copy and paste the MAC addresses from the wireless-N modem
router's Attached Devices screen into the MAC Address field of this screen. To
do this, configure each wireless computer to obtain a wireless link to the
wireless-N modem router. The computer should then appear in the Attached
Devices screen.
Advanced Configuration
Wireless-N 300 Modem Router DGN2200 User Manual
v1.0, March 2010
6-13