•
Checking for Firmware Updates screen. After initial configuration, this screen displays
unless you previously cleared the Check for Updated Firmware Upon Log-in check box.
Figure 1-2
Note: If the wireless-N modem router is not configured (is in its factory default state)
when you log in, the Setup Wizard displays. See
page
If the wireless-N modem router discovers a newer version of the firmware, you are asked if
you want to upgrade to the new firmware (see
details). If no new firmware is available, the following message displays.
Figure 1-3
•
Router Status screen. The Router Status screen displays if the wireless-N modem router has
not been configured yet or has been reset to its factory default settings. See
Usage Statistics" on page
You can use the Setup Wizard to automatically detect your Internet connection as described in
"Using the Setup Wizard" on page
configure your Internet connection as described in
ISP Settings" on page
Configuring Your Internet Connection
Wireless-N 300 Modem Router DGN2200 User Manual
1-4.
4-5.
1-4, or you can bypass the Setup Wizard and manually
1-5.
v1.0, March 2010
"Using the Setup Wizard" on
"Upgrading the Firmware" on page 4-1
"Viewing or Manually Configuring Your
for
"Router Status and
1-3