FUTABA FX-36 Software

1M23Z05511
This software updates or alters the functions and features noted below. The instructions and information that follow are meant as a
supplement to the original instruction manual that accompanied the transmitter. Please refer to the original instruction manual where
applicable, but replace the steps indicated below with these instructions. Please check to ensure that the update has been installed.
1) Select the System Menu.
2) Touch the [Information] button.
3) Confirm that the information in the display indicates the version numbers as noted above.
1. Add Model ID
As an added level of safety in the form of Model ID, which will prevent the accidental control of a model
when using a different model data by preventing link.
In Ver 3.9 or later software with the model ID function added, model data saved on the SD card cannot be called
using the model select function. To use the model data of the SD card, copy the model data to the transmitter.
If the model data of the SD card was selected before the update, an error message will be displayed at the first
startup after the update, and the model will automatically switch to the model data of the transmitter.
FX-36 SOFTWARE UPDATE CHANGES
Conventional system
1: Model 1
2: Model 2
3: Model 3
Model 2 selected*
Since it can control other
models regardless of the active model, there is a
risk of flying with the wrong model data !
Model ID
1: Model 1
2: Model 2
3: Model 3
Model 2 is selected*
Model 2 only works with model 2 data.
There is no risk of flying with the wrong model data.
V3.9
Rx 1
Operation
Rx 2
Operation
Rx 3
Operation
Rx 1
No Operation
Rx 2
Operation
Rx 3
No Operation
FASSTest, T-FHSS