Table of Contents
Advertisement
Function
When you select model and wing (swash) types,
you will find that the optimized combinations of
servo output channels and functions have been
already preset. If you would like, on the function-
setting screen of the linkage menu, you can freely
change combinations of servo output channels,
functions (aileron, elevator, etc), and input
controllers (sticks, switches, trim levers and trim
switches). You can also assign the same function to
multiple servo output channels such as assigning
elevator function to CH2 and CH3.
DG1, DG2 (switch channels)
These two channels can be used as switch
channels. You can freely change combinations
between servo output channels and input controllers
(sticks, switches, trim levers and trim switches).
VC1~VC4 (virtual channels)
These four channels can be set as virtual functions
that do not have servo output channels. You can
freely change combinations between functions
(aileron, elevator, etc) and input controllers (sticks,
switches, trim levers and trim switches).
Function change
*Multiple channels can be assigned to 1 function.
60
<Linkage Menu>
Servo Output Channels
channels and two digital channels. For PCM1024
mode, you can set eight linear channels and one
digital channel. For PPM mode, you can set only
eight linear channels.
(The display screen is an example. The screen depends on the model type.)
Operation control change
For PCMG3 mode, you can set twelve linear
*The same control can be assigned to multiple channels.
(VC1-4, DC-1-2)
Advertisement
Table of Contents
