Table of Contents
Advertisement
is used to stabilize the fuselage attitude. The
mode) can be changed with a switch.
switched.
simultaneously controlled.
*Initial setting does not assign a sensitivity channel. Use the
to call the setup screen shown below.
(For a description of the switch selection method, see the description at
the end of this manual.)
*When separating the conditions, set to [Sngl].
front position.
Since switch E is turned OFF at the center, Rate 2 remains [INH].
100
<Model Menu (Airplane/Glider Functions)>
Function menu of the Linkage Menu to assign the sensitivity
beforehand.
Set [ACT] and [Trim] other than Function to [NULL].
the 3 axes Gyro/Gyro2/Gyro3 can be set.
(Gr./Sngl)
(For more information, see the description
at the back of this manual.)
Advertisement
Table of Contents
