Installing Fixed Hard Drive(S); Figure 29. Tightening Thumb Screw - Intel SC5600LX - Server Chassis - Tower Service Manual

15. Reinstall the fixed hard drive into the chassis.
16. If other hard drives remain in the drive cage, reconnect the power and data cables.
17. Install the front bezel. For instructions, see "Removing and Installing the Front Bezel."
18. Install the chassis cover. For instructions, see "Installing the Chassis Cover."
19. Plug all peripheral devices and the AC power cable into the server.
20. Power up the server.

Installing Fixed Hard Drive(s)

1. Observe the safety and ESD precautions at the beginning of this book.
2. Power down the server and unplug all peripheral devices and the AC power cable.
3. Remove the chassis cover. For instructions, see "Removing the Chassis Cover."
4. If it is installed, remove the front bezel. For instructions, see "Removing and Installing the Front Bezel."
5. Push the blue plastic release mechanism upward to release the fixed drive cage (see letter "A" Figure 30).
Pull the drive cage out about two inches (see letter "B") so it is partially exposed from the drive bay slot in
the chassis. Partially exposing the drive cage makes it easier to open the upper door of the drive cage.
/
NOTE
As an alternative, you may also fully remove the drive cage from its drive bay slot in the chassis. Take
care, however, to position the drive cage horizontally before opening the drive cage doors or the drive
rails will spill out.
Server
Intel® Chassis SC5600 Service Guide

Figure 29. Tightening Thumb Screw

Hardware Installations and Upgrades
31