Installing A 5.25-Inch Or 3.5-Inch Hard Drive; Removing A Drive Carrier - Intel SC5000 Subassembly Product Manual

Installing a 5.25-inch or 3.5-inch Hard Drive

Five (two if the optional hot swap drive bay is installed) 5.25-inch half-height bays provide space
for hard drives.
1. If you haven't already done so, remove the top piece of foam epac from the system fans.
2. Remove and save the two screws that secure the drive carrier to the chassis.
3. Slide the drive carrier out of the chassis. You may need to push the drive from the inside of
the chassis.
4. Remove the drive from its protective wrapper and place it on an antistatic surface.
5. Record the drive model and serial numbers in your equipment log.
6. Set any jumpers or switches on the drive according to the drive manufacturer's instructions.
Setting Up the Chassis
Figure 17. Removing a Drive Carrier
OM09176
29