Configuring Dhcp Vlan Settings; Figure 136 Ip Application > Dhcp > Vlan; Table 91 Ip Application > Dhcp > Vlan - ZyXEL Communications MES-3728 User Manual

28.4 Configuring DHCP VLAN Settings

Use this screen to configure your DHCP settings based on the VLAN domain of the DHCP
clients. Click IP Application > DHCP in the navigation panel, then click the VLAN link In
the DHCP Status screen that displays.
You must set up a management IP address for each VLAN that you want to
configure DHCP settings for on the Switch.
See Section 7.6 on page 81
VLANs.
Figure 136 IP Application > DHCP > VLAN
The following table describes the labels in this screen.
Table 91 IP Application > DHCP > VLAN
LABEL
VID
Remote DHCP
Server 1 .. 3
Relay Agent
Information
Information
Add
MES-3728 User's Guide
for information on how to set up management IP addresses for
DESCRIPTION
Enter the ID number of the VLAN to which these DHCP settings apply.
Enter the IP address of a DHCP server in dotted decimal notation.
Select the Option 82 check box to have the Switch add information (slot number, port
number and VLAN ID) to client DHCP requests that it relays to a DHCP server.
This read-only field displays the system name you configure in the General Setup
screen.
Select the check box for the Switch to add the system name to the client DHCP
requests that it relays to a DHCP server.
Click Add to save your changes to the Switch's run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are
done configuring.
Chapter 28 DHCP
245