Removing The Transport Assembly - HP A5585A - SureStore DLT E Tape Library 4/40 Upgrade And Replacement Instructions

CAUTION
NOTE
Figure 2-13
Removing and Replacing Major Library Components
Removing and Replacing the Transport Assembly (for Models 2/20, 4/40, and 6/60 only)

Removing the Transport Assembly

Use the following steps to remove the transport assembly:
1. Using the finger-holes in the top of the transport assembly, lift the
assembly up and out of the library (Figure 2-13).
Use care to protect the flat, umbilical cable attached to the bottom of the
transport assembly when lifting.
The illustration on the left is for Models 4/40 and 6/60 and shows the
vertical lift assembly connected to the transport assembly. The
illustration on the right is for Model 2/20, which does not have a vertical
lift assembly.
Removing the Transport Assembly
2. Place the transport assembly on top of the library, and disconnect the
umbilical cable from the motherboard by pulling the tabs outward
(Figure 2-13).
2-32 Chapter 2