Configuring The Remote Management Card; Install And Configure The Remote Management Card; Installation; Configuration - HP A5585A - SureStore DLT E Tape Library 4/40 Upgrade And Replacement Instructions

Configuring the Library

Configuring the Remote Management Card

Configuring the Remote Management Card

Install and Configure the Remote Management Card

All library models only require one remote management card.

Installation

Refer to "Removing and Replacing Cards" on page 2-18 for information
about installing the remote management card.

Configuration

1. Connect to the network port of the card using a category 5 ethernet
cable.
2. On the library's back panel, verify that the link LED on the remote
management card is green. If the LED is not green, a link has not
been established with the local network. Ensure the network port is
active by checking with the system administrator. (See Table 3-3 on
page 3-10 for a description of the LEDs.)
3. Enter the
Network Access
->
Main Menu
Administration
Change Configuration
4. If you would like to use DHCP/BOOTP to configure the remote
management card, select
configuration through DHCP/BOOTP or alert you if DHCP/BOOTP
failed. If successful, note the IP address, and skip to step 9.
If DHCP/BOOTP was not successful, or if you do not want to use
DHCP/BOOTP, contact the system administrator to obtain an IP
address, subnet mask, and gateway address, and continue with the
next step.
A-2
menu.
->
->
Network Access
. A message will display to confirm the
[Yes]
Appendix A