Removing And Replacing The Transport Assembly; Accessing The Transport Assembly - HP A5585A - SureStore DLT E Tape Library 4/40 Upgrade And Replacement Instructions

NOTE
WARNING
AVERTISSEMENT
Removing and Replacing Major Library Components
Removing and Replacing the Transport Assembly (for Models 2/20, 4/40, and 6/60 only)
Removing and Replacing the Transport
Assembly (for Models 2/20, 4/40, and 6/60 only)
Level of Difficulty: [5] Difficult
For Model 12/140, refer to page 2-36.
The instructions for this assembly are divided into the following sections:
• "Accessing the Transport Assembly" on page 2-28
• "Removing the Transport Assembly" on page 2-32
• "Replacing the Transport Assembly" on page 2-33
• "Replacing the Cover" on page 2-35
Two Field Replaceable Units (FRUs) are involved with the transport
assembly: the transport assembly and the vertical lift assembly. Either
assembly may be replaced separately, but both must be removed to
replace either one.

Accessing the Transport Assembly

Use the following steps to access the transport assembly:
1. Power off the library.
2. If the library is rackmounted, use the following steps to slide it
forward in the rack:
a. Lower the rack's lever feet, and fully extend the anti-tip foot at the
bottom front of the rack.
Failure to extend the anti-tip device could result in personal
injury or damage to the tape library if the rack tips over.
Si vous ne déployez pas le dispositif antibasculant, le rack risque de
se renverser et de provoquer des blessures ou d'endommager
l'autochargeur de bande.
2-28 Chapter 2