You can also check your current firmware revisions from the remote
management card:
1. Enter the designated IP address into the web browser to launch the
2. Select the
3. Scroll down to the
NOTE
Ensure that your backup software does not "SCSI reserve" the library, as
this can prevent a firmware download.
Using the Remote Management Card (library
firmware only)
You can download firmware to all library components, except drives,
from the remote management card.
1. Once the library is configured for network access, enter the IP
2. Select the
3. Select the
4. Enter the full pathname for the download file, or use the
Refer to the tape library user's guide for information on how to obtain
NOTE
library firmware files or contact your service representative.
The library administrator password is required for this process and is not
NOTE
set by default. If the password is not set, you will not be permitted to
download firmware. (Refer to your user's guide for information on
enabling and changing your password.)
Chapter 3
Web-Based Library Administrator pages (see "Configuring the
Remote Management Card" on page A-2).
tab.
[Report]
Firmware Revisions
library and drive firmware revisions.
address within your web browser to launch the Web-Based Library
Administrator pages. See "Configuring the Remote Management
Card" on page A-2 for more information.
[Configuration]
[Firmware Download]
button to locate the file.
Downloading Firware and Interpreting LEDs
section of the page to view your
tab from the main screen.
button.
Upgrading Firmware
[Browse]
3-3