HP A5585A - SureStore DLT E Tape Library 4/40 Upgrade And Replacement Instructions page 124

NOTE
Configuring the Library
Configuring the Library for Fibre Channel
• If you selected hard addressing for a loop connection, select the
AL_PA (fixed address) or choose auto-select. Auto-select is an
option under hard addressing that selects an available address
and then uses it as a hard address from then on.
7. Press when complete to save the changes, or select
[OK]
return to the beginning of the fibre configuration menu. If you select
, a message will display indicating the old values will be
[QUIT]
retained.
If you select
[OK]
are being stored onto the Fibre Channel controller card. If this is
successful, a message displays indicating that the new settings will
be attempted at the next restart.
8. To immediately apply the new settings, select
to wait until the next power cycle.
[DONE]
When the Fibre Channel controller card is restarted, or when the
library is power-cycled,
. The Fibre Channel controller card always attempts to
SETTINGS
connect using
CURRENT SETTINGS
• If you select
[RESTART]
restarted. This should not be attempted if data transfers or library
operations are in progress. The
completes within 90 seconds. The display will report the status of
the operation when it is complete.
The actual connection achieved depends on the external topology and
network. Consequently,
.
SETTINGS
A-6
, a message will display indicating that the settings
FUTURE SETTINGS
.
, the Fibre Channel controller card is
[RESTART]
CURRENT STATUS
[QUIT]
, or select
[RESTART]
are copied into
CURRENT
operation normally
may differ from
CURRENT
Appendix A
to