Unpacking Hd Receiver And Accessories/Connection Overview - Zenith HDR230 Installation And Operating Manual, Warranty

Unpacking HD Receiver and Accessories/Connection Overview

Make sure you have received all these items listed below with the High Definition Television Receiver.
High Definition Television Receiver
The HDTV Receiver is capable of receiving signals from cable and/or over-the-air antenna
sources and sending the signals to your TV.
Included with the Receiver are the following accessories.
Audio Cable/Video Cable/Component(YPbPr) Cable
RF Cable and Attenuator
Remote Control and 2 AA Batteries
8
Audio/Video Jacks and Cables
The Audio/Video jacks provide excellent picture and sound quality. They are
used for making most Audio/Video connections between components. The
Audio/Video jacks may be color coded (yellow for video, red for right audio,
and white for left audio). If your component has only one input for audio
(mono), connect it to the left (white L/mono) audio jack on the HDTV
Receiver.
Component Out Jacks and Cables
Component Cables are used to connect the HDTV Receiver to an industry
standard YPbPr compatible HD Monitor. Remember to connect the left and
right audio cables. The YPbPr Component jacks carry only the picture
signals, not the sound.
ANT LOOP OUT Jack, and RF Cable
ANT LOOP OUT provides an RF connection between the HDTV Receiver
and the TV and provides the signal of ANT IN jack to TV.
Attenuator
During initial installation and setup of your Zenith HDTV Receiver, you may
need to install the 10 dB attenuator to the Antenna input "ANT IN" on the
HDR230. Details are on page 9.
Remote Control
In addition to the HDTV Receiver, the remote control can be programmed to
control many other devices.
Batteries
To install the batteries, slide open the battery compartment and insert the
two AA batteries provided.