Connecting To A Hd Monitor (Ypbpr Type) - Zenith HDV420 Installation And Operating Manual, Warranty

Connections (Continued)

Connecting to a HD monitor (YPbPr type)

Antenna
Connect the "Antenna" to the "ANT IN" jack on the HDTV Receiver using a coaxial RF cable.
1 1
ote
There might be some areas where the signal strength could is too high. If so, you may need to connect the antenna
to an attenuator and screw the attenuator onto the "ANT IN" jack. (Refer to page 9.)
Connect the "ANT LOOP OUT" jack on the HDTV Receiver to the "ANT IN" jack on your TV using a coaxial RF
2 2
cable.
Connect the "COMPONENT OUT" jacks on the HDTV Receiver to the "COMPONENT IN" jacks of your TV
3 3
using RCA-type cables. (The OUTPUT SELECTION switch must be set to YPbPr.)
Connect the L/R "AUDIO OUT" jacks on the HDTV Receiver to the L/R "AUDIO IN" jacks on your TV using
4 4
RCA-type cables.
ote
The component out jacks are available when 480p, 720p, or 1080i display format is selected.
Cable TV
wall jack Rear of HD Ready TV
S-VIDEO
INPUT
OR
ANTENNA VIDEO
AUDIO INPUT
COMPONENT VIDEO INPUT
INPUT INPUT
Pr
L R
Rear of HDTV Receiver
Y
Pb
L
11