Connections (Continued)
HD Monitor RGB Connections
Antenna
1 1
Connect the "Antenna" to the "ANT IN" jack on the HDTV Receiver using a coaxial RF cable.
1 1
ote
There might be some areas where the signal strength could be too high. If so, you may need to connect the
antenna to the attenuator supplied and screw the attenuator onto the "ANT IN" jack. (Refer to page 9.)
Connect the "ANT LOOP OUT" jack on the HDTV Receiver to the "Antenna In" jack on your TV using a coaxial
2 2
RF cable.
Connect the "RGB OUT" jack on the HDTV Receiver to the "RGB IN" jack of your TV using VGA-type connector.
3 3
(The OUTPUT SELECTION switch must be set to RGB.)
Connect the L/R "AUDIO OUT" jacks on the HDTV Receiver to the L/R "AUDIO IN" jacks on your TV using RCA-
4 4
type cables.
ote
RGB OUT is available only when 480p, 720p, or 1080i display format is selected.
12
Cable TV
Wall Jack Panel
OR
HD Ready TV Connection Panel
ANTENNA
S-VIDEO
VIDEO
INPUT
INPUT
INPUT
L
HDTV Receiver Connection Panel
AUDIO INPUT
RGB INPUT
R
L