Analog Monitor Connections - Zenith HDR230 Installation And Operating Manual, Warranty

Connections (Continued)
Display Formats Overview
The HDTV Tuner offers various display formats and multiple video outputs. When the HDTV Tuner is connected to
•
A/V systems, the HDTV Tuner can provide video signal formats 1080i, 720p, 480p, or 480i.
1080i, 720p and 480p modes are available for component video (YPbPr) and monitor outputs.
•
480i mode is available for VIDEO and S-VIDEO outputs.
•
The HDTV Tuner has two digital audio outputs; Dolby Digital 5.1 and PCM. The HDTV Tuner sends out digital
•
audio signal to OPTICAL and COAXIAL audio outputs when digital broadcasts are being received by the HDTV
Tuner.

Analog Monitor Connections

Antenna
Wall Jack Panel
OR
Connect the "Antenna" to the "ANT IN" jack on the HDTV Receiver using a coaxial RF cable.
1 1
ote
There might be some areas where the signal strength could be too high. If so, you may need to connect the
antenna to the attenuator supplied and screw the attenuator onto the "ANT IN" jack. (Refer to page 9.)
Connect the "ANT LOOP OUT" jack on the HDTV Receiver to the "Antenna In" jack on your TV using a coaxial
2 2
RF cable.
Connect the "AUDIO OUT" and "VIDEO OUT" jacks on the HDTV Receiver to the "A/V IN" jack on your TV using
3 3
RCA-type cables. If your VCR is equipped with an S-Video jack, use the S-VIDEO OUT jack.
ote
These connections are only available when 480i display format is selected.
10
Cable TV
TV Connection Panel
ANTENNA S-VIDEO
COMPONENT VIDEO INPUT
INPUT INPUT
Pr Pb
OR
HDTV Receiver Connection Panel
VIDEO
AUDIO INPUT
INPUT
Y
R
L L