Programming The Remote Control; For Other Devices - Zenith HDR230 Installation And Operating Manual, Warranty

Programming the Remote Control to Operate Other Devices
36
The HDTV Receiver remote control is a multi-brand or universal remote con-
trol that can be programmed to control most remote-controllable devices from
other manufacturers.
ote
The remote control may not be able to control all models of other brands.
Test your remote control.
1 1
To find out whether your remote control can operate a device without
programming. Turn on the device such as a VCR and select the corre-
sponding mode (VCR) by pressing MODE on the remote control while
pointing at the device. Use the POWER and CH +/- buttons to see if the
device responds properly. If not, the remote control requires program-
ming.
Turn on the device to be programmed. Then select the correspon-
2 2
ding mode (VCR, AUX, TV, DVD or STB) by pressing MODE on the
remote control.
Press the POWER button and the MUTE button simultaneously.
3 3
The remote control is now ready to program the code for the device.
There are two ways to find the correct code for the device.
4 4
First, if you press the CH + buttons repeatedly, the codes will change
one at a time. If the right code is found, the device will turn off.
Second, enter the code number using the number buttons on the remote
control. The right code numbers for the corresponding device can be
found on the following pages. If the code is correct, the device will turn
off.
Press the EXIT button to store the programming code.
5 5
Test the remote control functions to see if the device responds
6 6
properly. If not, repeat from step 2.