Aux Controller: Connection And Placement; Ir Receiver & Ir Bracket Installation - Zenith HCS5650 Installation And Operating Manual

AUX Controller: Connection and Placement

Connect the AUX Controller to allow the Integrator Box to operate your AUX device.
1
Connect the AUX Controller to the AUX CONTROL cord on the TV/STB.
Place the AUX Controller under and in front of the AUX device.
2
The AUX Controller must extend just out in front of the infrared sensor on the AUX device.
*Note:
If the infrared sensor is not marked on your AUX device, shine a flashlight into the front panel of the AUX device to locate
the sensor.
IR Receiver & IR Bracket Installation
Install the IR Receiver and Bracket Assembly to the back of the monitor using the method described
below.
IR Receiver & Bracket Installation
THE IR RECEIVER UNIT IS PROVIDED. THIS WILL NEED TO BE MOUNTED ON THE MONITOR BACK WITH TWO-SIDED TAPE.
P A G E 1 0
PILLOW INT
AUDIO IN AUDIO OUT
REMOTE
IN
1 2
PILLOW JACK IN AUX DIGITAL
DIGITAL
(12V DC 40mA) CONTROL VIDEO OUT
VIDEO IN
AUX Controller
IR Sensor
DVD (Front View)
Monitor
IR Receiver
IR Bracket
PILLOW INT
AUDIO IN
REMOTE
IN
PILLOW JACK IN AUX 1
DIGITAL
(12V DC 40mA) CONTROL
VIDEO IN
AC OUT 8A AC IN 120V~ 60Hz
SERVICE
DIGITAL AUDIO DISPLAY
OUT (OPTICAL) CONTROL
Connections Panel
DVD
(Side View)
AC OUT 8A AC IN 120V~ 60Hz
AUDIO OUT SERVICE
2 DIGITAL DIGITAL AUDIO DISPLAY
VIDEO OUT OUT (OPTICAL) CONTROL
Connections Panel
1/2"
to 1"