NEC POWERMATE 5100 Manual page 187

Hide thumbs Also See for POWERMATE 5100:
Table of Contents

Advertisement

T
Non-System Disk error message displays when the
system is started.
You have a diskette in the diskette drive, and the diskette
drive is set before the hard drive in boot order. Remove
the diskette from drive A and restart the system.
T
Operating system not found error message displays
when the system is started.
If you left a CD in the CD-ROM drive, the system may not
be able to boot. Try removing the CD and rebooting.
The hard drive might need more time to spin up before the
system boots. Change the "Hard Disk Delay" to a higher
setting from the BIOS Setup utility "Boot" menu.
T
System does not boot and error message displayed
on screen.
Run the Setup Utility (see Chapter 3). Check that the
parameters are set correctly, particularly if you just
installed an option.
T
System emits continuous beeps.
Turn the system off, wait at least five seconds, and turn the
system on. If the beeps continue, call your NEC CSD
dealer or the NEC CSD Technical Support Center.
T
System does not maintain date, time, system
configuration information.
Change the battery (see "Battery Replacement" in this
chapter). For assistance, call your NEC CSD dealer or the
NEC CSD Technical Support Center.
T
System does not boot from hard drive.
The system usually tries to start from the diskette drive
before it starts from the hard drive. Remove the diskette
from the diskette drive.
Solving System Problems 6-3

Advertisement

Table of Contents
loading

This manual is also suitable for:

Powermate 5100 series

Table of Contents