Table of Contents
Advertisement
Correct alignment of the system board
A – Rail B – Latch Open C – Edge of Chassis
D – Edge of System Board
4. Push the latch closed. This slides the board the rest of the
way into the system unit and secures it into the riser board
connector.
! CAUTION
If the board does not slide when you push the
latch, slide the board out of the unit a bit and
check the alignment position (see the previous
figure). Push the latch closed.
When the system board is aligned correctly, you might
need to push the outside edges of the board to fully seat it
into the riser board connector.
Installing Options 5-13
Advertisement
Table of Contents
