Table of Contents
Advertisement
6. Insert the bracket in the chassis slots (orient the cable
connectors toward the rear of the system) and align the
screw holes.
7. Insert and tighten the two screws to secure the bracket
inside the chassis.
Securing an internal hard drive to the chassis
A – Bracket Screws B – Internal Hard Drive Screws
C – Internal Hard Drive D – Bracket Slots
8. Connect the device cables (see "Connecting Device
Cables" and "Cabling an IDE Device").
9. Replace the system unit cover (see "Replacing the
Cover").
10. Run the Setup program to set the new configuration (see
"BIOS Setup Utility" in Chapter 3).
Installing Options 5-45
Advertisement
Table of Contents
