Table of Contents
Advertisement
3. Move the jumper to pins 2 and 3. This jumper setting
brings the system up in Configure mode when it is
rebooted.
4. Replace the system unit cover (see "Replacing the
Cover"). Connect system power cables and external
options.
5. Power on the system. The BIOS Setup utility launches
immediately after POST displaying the Maintenance
menu.
6. Select the Processor Speed field. Press
subwindow appears displaying the supported processor
speeds.
7. Use the up or down arrow key to select the correct
processor speed. Press
8. Select the
Press
Enter
confirm that you wish to exit the BIOS Setup utility.
9. Power off and unplug the system and any external options
again. Remove the system unit cover (see "Removing the
Cover").
10. Move the J6C1 jumper back to pins 1 and 2 so the system
can restart in normal operation mode.
11. Replace the system unit cover (see "Replacing the
Cover"). Connect system power cables and external
options.
12. Power on the system and launch the BIOS Setup utility
before POST and re-customize your BIOS settings.
3-58 Configuring the System
Enter
.
menu with the left or right arrow key.
Exit
to exit saving changes. Press
. A
Enter
Enter
again to
Advertisement
Table of Contents
