Max Tx Rate - You can limit the maximum transmission rate of the
◆
Router through this field.
Disable Security - The wireless security function can be enabled or
◆
disabled. If disabled, the wireless stations will be able to connect the
Router without encryption. It is recommended strongly that you choose
one of following options to enable security.
WPA-PSK/WPA2-PSK - Select WPA based on pre-shared passphrase.
◆
PSK Password - You can enter ASCII or Hexadecimal characters.
■
For ASCII, the key can be made up of any numbers 0 to 9 and any
letters A to Z, the length should be between 8 and 63 characters.
For Hexadecimal, the key can be made up of any numbers 0 to 9
and letters A to F, the length should be between 8 and 64
characters.
Please also note the key is case sensitive, this means that upper
and lower case keys will affect the outcome. It would also be a good
idea to write down the key and all related wireless security settings.
◆
No Change - If you chose this option, wireless security configuration
will not change!
These settings are only for basic wireless parameters. For advanced
settings, please refer to
Click the Next button. You will then see the Finish page.
6.
If you don't make any changes on the Wireless page, you will see the
Finish page as below. Click the Finish button to finish the Quick Setup.
Figure 13: Quick Setup - Finish
If there is something changed on the Wireless page, you will see the Finish
page as in the following figure. Click the Reboot button to make your
wireless configuration take effect and finish the Quick Setup.
– 32 –
C
HAPTER
"Wireless Settings" on page
| Quick Installation Guide
3
Quick Installation Guide
53.