SMC Networks BARRICADETM SMCWGBR14-N2 User Manual page 31

Click Next to continue, the Wireless settings page will appear.
5.
Figure 12: Quick Setup - Wireless
◆ Wireless Radio - Enable or disable the wireless radio choosing from
the pull-down list.
SSID - Enter a value of up to 32 characters. The same name of SSID
◆
(Service Set Identification) must be assigned to all wireless devices in
your network. Considering your wireless network security, the default
SSID is set to be "SMC". This value is case-sensitive. For example,
"TEST" is NOT the same as "test".
Region - Select your region from the pull-down list. This field specifies
◆
the region where the wireless function of the Router can be used. It
may be illegal to use the wireless function of the Router in a region
other than one of those specified in this field. If your country or region
is not listed, please contact your local government agency for
assistance.
◆ Channel - This field determines which operating frequency will be
used. The default channel is set to Auto, so the AP will choose the best
channel automatically. It is not necessary to change the wireless
channel unless you notice interference problems with another nearby
access point.
Mode - This field determines the wireless mode which the Router works
◆
on.
Channel Width - Select any channel width from the pull-down list. The
◆
default setting is automatic, which can adjust the channel width for
your clients automatically.
– 31 –
| Quick Installation Guide
C 3
HAPTER
Quick Installation Guide