Advance Settings - SMC Networks 7904WBRA4 - annexe 1 Manual

The following table describes the parameters and buttons of this page.
Field
SSID TYPE
Key Length
Key Format
Default Tx Key
Encryption Key 1 to 4
Apply Changes
Close
Undo
3.5.3

Advance Settings

Choose WLAN > Advance Settings. The page shown in the following figure appears. These settings are only for
more technically advanced users who have a sufficient knowledge about wireless LAN. These settings should not
be changed unless you know the effect of the changes on your AP.
Select the SSID.
Select 64-bit or 128-bit to use data encryption.
If you choose 64-bit, you can choose ASCII (5 characters) or Hex (10
characters).
If you choose 128-bit, you can choose ASCII (13 characters) or Hex (26
characters).
Select the default encryption key.
The Encryption keys are used to encrypt the data. Both router and wireless stations
must use the same encryption key for data transmission.
If you choose 64-bit and ASCII (5 characters), enter any 5 ASCII characters.
If you choose 64-bit and Hex (10 characters), enter any 10 hexadecimal
characters.
If you choose 128-bit and ASCII (13 characters), enter any 13 ASCII
characters.
If you choose 128-bit and Hex (26 characters), enter any 26 hexadecimal
characters.
Save the changes of this page.
Close this page.
Refresh this page.
Description
28