Configuring Snmpv3 Groups - SMC Networks 7824M/FSW - annexe 1 Management Manual

S N
IMPLE ETWORK
CLI – Use the snmp-server user command to configure a new user name
and assign it to a group.
Console(config)#snmp-server user mark group r&d remote 192.168.1.19
v3 auth md5 greenpeace priv des56 einstien
Console(config)#exit
Console#show snmp user
No user exist.
SNMP remote user
EngineId: 80000000030004e2b316c54321
User Name: mark
Authentication Protocol: none
Privacy Protocol: none
Storage Type: nonvolatile
Row Status: active
Console#

Configuring SNMPv3 Groups

An SNMPv3 group sets the access policy for its assigned users, restricting
them to specific read, write, and notify views. You can use the pre-defined
default groups or create new groups to map a set of SNMP users to SNMP
views.
Command Attributes
• Group Name – The name of the SNMP group. (Range: 1-32 characters)
• Model – The group security model; SNMP v1, v2c or v3.
• Level – The security level used for the group:
- noAuthNoPriv – There is no authentication or encryption used in
SNMP communications.
- AuthNoPriv – SNMP communications use authentication, but the
data is not encrypted (only available for the SNMPv3 security model).
- AuthPriv – SNMP communications use both authentication and
encryption (only available for the SNMPv3 security model).
• Read View – The configured view for read access. (Range: 1-64
characters)
• Write View – The configured view for write access. (Range: 1-64
characters)
5-18
M
ANAGEMENT
P
ROTOCOL
20-18
20-20