Table of Contents
Advertisement
M
F
ULTICAST
ILTERING
Static Multicast Routing Commands
This section describes commands used to configure static multicast
routing on the switch.
Command
ip igmp snooping vlan
mrouter
show ip igmp snooping
mrouter
ip igmp snooping vlan mrouter
This command statically configures a multicast router port. Use the no
form to remove the configuration.
Syntax
[no] ip igmp snooping vlan vlan-id mrouter interface
• vlan-id - VLAN ID (Range: 1-4093)
• interface
• ethernet unit/port
• port-channel channel-id (Range: 1-12)
Default Setting
No static multicast router ports are configured.
Command Mode
Global Configuration
Command Usage
Depending on your network connections, IGMP snooping may not
always be able to locate the IGMP querier. Therefore, if the IGMP
querier is a known multicast router/switch connected over the network
to an interface (port or trunk) on your router, you can manually
configure that interface to join all the current multicast groups.
35-12
C
OMMANDS
Table 35-4 Static Multicast Routing Commands
Function
Adds a multicast router port
Shows multicast router ports
- unit - Stack unit. (Range: 1)
- port - Port number. (Range: 1-19)
Mode Page
GC
35-12
PE
35-13
Advertisement
Table of Contents
