SMC Networks 7824M/FSW - annexe 1 Management Manual page 178

A C
CCESS ONTROL
• Source/Destination IP Address – Source or destination IP address.
• Source/Destination Subnet Mask – Subnet mask for source or
destination address. (See the description for SubMask on page 8-4.)
• Service Type – Packet priority settings based on the following criteria:
- Precedence – IP precedence level. (Range: 0-8, where 8 means any)
- TOS – Type of Service level. (Range: 0-16, where 16 means any)
- DSCP – DSCP priority level. (Range: 0-64, where 64 means any)
• Protocol – Specifies the protocol type to match as TCP, UDP or Others,
where others indicates a specific protocol number (0-255). (Options:
TCP, UDP, Others; Default: TCP)
• Source/Destination Port – Source/destination port number for the
specified protocol type. (Range: 0-65535)
• Source/Destination Port Bit Mask – Decimal number representing
the port bits to match. (Range: 0-65535)
• Control Code – Decimal number (representing a bit string) that
specifies flag bits in byte 14 of the TCP header. (Range: 0-63)
• Control Code Bit Mask – Decimal number representing the code bits
to match.
The control bitmask is a decimal number (for an equivalent binary bit
mask) that is applied to the control code. Enter a decimal number, where
the equivalent binary bit "1" means to match a bit and "0" means to
ignore a bit. The following bits may be specified:
- 1 (fin) – Finish
- 2 (syn) – Synchronize
- 4 (rst) – Reset
- 8 (psh) – Push
- 16 (ack) – Acknowledgement
- 32 (urg) – Urgent pointer
For example, use the code value and mask below to catch packets with
the following flags set:
- SYN flag valid, use control-code 2, control bitmask 2
- Both SYN and ACK valid, use control-code 18, control bitmask 18
- SYN valid and ACK invalid, use control-code 2, control bitmask 18
8-6
L
ISTS