Static Multicast Routing Commands; Ip Igmp Snooping Vlan Mrouter; Table 4-76 Static Multicast Routing Commands - SMC Networks SMC8748ML3 Management Manual

Static Multicast Routing Commands

Command
ip igmp snooping vlan
mrouter
show ip igmp snooping
mrouter

ip igmp snooping vlan mrouter

This command statically configures a multicast router port. Use the no form
to remove the configuration.
Syntax
[no] ip igmp snooping vlan vlan-id mrouter interface
• vlan-id - VLAN ID (Range: 1-4093)
• interface
• ethernet unit/port
• port-channel channel-id (Range: 1-32)
Default Setting
No static multicast router ports are configured.
Command Mode
Global Configuration
Command Usage
Depending on your network connections, IGMP snooping may not
always be able to locate the IGMP querier. Therefore, if the IGMP
querier is a known multicast router/switch connected over the network to
an interface (port or trunk) on your router, you can manually configure
that interface to join all the current multicast groups.

Table 4-76 Static Multicast Routing Commands

Function
Adds a multicast router port
Shows multicast router ports
- unit - Stack unit. (Range: 1-8)
- port - Port number. (Range: 1-25/49)
M F
ULTICAST ILTERING
C
OMMANDS
Mode Page
GC 4-305
PE 4-306
4-305