Configuring 802.1X Global Settings; Configuring Port Settings For 802.1X; Figure 3-53 802.1X Global Configuration - SMC Networks 6128PL2 - annexe 2 Management Manual

3
Configuring the Switch

Configuring 802.1X Global Settings

The 802.1X protocol provides port authentication. The 802.1X protocol must be
enabled globally for the switch system before port settings are active.
Command Attributes
• 802.1X System Authentication Control – Sets the global setting for 802.1X.
(Default: Disabled)
Web – Select Security, 802.1X, Configuration. Enable 802.1X globally for the switch,
and click Apply.
CLI – This example enables 802.1X globally for the switch.
Console(config)#dot1x system-auth-control
Console(config)#

Configuring Port Settings for 802.1X

When 802.1X is enabled, you need to configure the parameters for the
authentication process that runs between the client and the switch (i.e.,
authenticator), as well as the client identity lookup process that runs between the
switch and authentication server. These parameters are described in this section.
Command Attributes
• Port – Port number.
• Status – Indicates if authentication is enabled or disabled on the port.
(Default: Disabled)
• Operation Mode – Allows single or multiple hosts (clients) to connect to an
802.1X-authorized port. (Options: Single-Host, Multi-Host; Default: Single-Host)
• Max Count – The maximum number of hosts that can connect to a port when the
Multi-Host operation mode is selected. (Range: 1-1024; Default: 5)
• Mode – Sets the authentication mode to one of the following options:
- Auto – Requires a dot1x-aware client to be authorized by the authentication
server. Clients that are not dot1x-aware will be denied access.
- Force-Authorized – Forces the port to grant access to all clients, either
dot1x-aware or otherwise. (This is the default setting.)
- Force-Unauthorized – Forces the port to deny access to all clients, either
dot1x-aware or otherwise.
3-86

Figure 3-53 802.1X Global Configuration

4-112