Interface Commands; Interface; Table 4-47 Interface Commands - SMC Networks 6128PL2 - annexe 2 Management Manual

4
Command Line Interface

Interface Commands

These commands are used to display or set communication parameters for an
Ethernet port, aggregated link, or VLAN.
Command

interface

description
speed-duplex
negotiation
capabilities
flowcontrol
shutdown
switchport packet-rate Configures the broadcast storm control threshold
clear counters
show interfaces status Displays status for the specified interface
show interfaces
counters
show interfaces
switchport
interface
This command configures an interface type and enters interface configuration mode.
Use the no form to remove a trunk.
Syntax
interface interface
no interface port-channel channel-id
interface
• ethernet unit/port
- unit - Stack unit. (Range: 1)
- port - Port number. (Range: 1-28)
• port-channel channel-id (Range: 1-8)
• vlan vlan-id (Range: 1-4092)
Default Setting
None
Command Mode
Global Configuration
4-166
Table 4-47 Interface Commands
Function
Configures an interface type and enters interface configuration
mode
Adds a description to an interface configuration
Configures the speed and duplex operation of a given interface
when autonegotiation is disabled
Enables autonegotiation of a given interface
Advertises the capabilities of a given interface for use in
autonegotiation
Enables flow control on a given interface
Disables an interface
Clears statistics on an interface
Displays statistics for the specified interfaces
Displays the administrative and operational status of an
interface
Mode Page
GC 4-166
IC 4-167
IC 4-167
IC 4-168
IC 4-169
IC 4-170
IC 4-171
IC 4-172
PE 4-172
NE, PE 4-173
NE, PE 4-174
NE, PE 4-175