Dir; Table 4-28 File Directory Information; Default Setting - SMC Networks 6128PL2 - annexe 2 Management Manual

4
Command Line Interface

dir

This command displays a list of files in flash memory.
Syntax
dir [unit:] {{boot-rom: | config: | opcode:} [:filename]}
The type of file or image to display includes:
• boot-rom - Boot ROM (or diagnostic) image file.
• config - Switch configuration file.
• opcode - Run-time operation code image file.
• filename - Name of the configuration file or code image.
• unit - Stack unit. (Range: 1)

Default Setting

None
Command Mode
Privileged Exec
Command Usage
• If you enter the command dir without any parameters, the system displays all
files.
• A colon (:) is required after the specified unit number.
• File information is shown below:
Column Heading
file name
file type
startup
size
Example
The following example shows how to display all file information:
Console#dir 1:
file name
-----------------------------------
D2218
V2271
Factory_Default_Config.cfg
---------------------------------------------------------------------------
Console#
4-88

Table 4-28 File Directory Information

Description
The name of the file.
File types: Boot-Rom, Operation Code, and Config file.
Shows if this file is used when the system is started.
The length of the file in bytes.
file type
--------------
Boot-Rom image
Operation Code
Config File
startup size (byte)
------- -------------
Y
Y
Y
Total free space:
214124
1761944
5197
5242880