Reload - SMC Networks 6128PL2 - annexe 2 Management Manual

4
Command Line Interface
Example
In this example, the show history command lists the contents of the command
history buffer:
Console#show history
Execution command history:
2 config
1 show history
Configuration command history:
4 interface vlan 1
3 exit
2 interface vlan 1
1 end
Console#
The ! command repeats commands from the Execution command history buffer
when you are in Normal Exec or Privileged Exec Mode, and commands from the
Configuration command history buffer when you are in any of the configuration
modes. In this example, the !2 command repeats the second command in the
Execution history buffer (config).
Console#!2
Console#config
Console(config)#

reload

This command restarts the system. You can reboot the system immediately, or you
can configure the switch to reset after a specified amount of time.
Syntax
reload [in hour hours | minute minutes]
hours - Specifies the amount of hours to wait, combined with the minutes,
before the switch resets. (Range: 0-576; Default: 0)
minutes - Specifies the amount of minutes to wait, combined with the hours,
before the switch resets. (Range: 1-34560; Default: 0)
Note:
When the system is restarted, it will always run the Power-On Self-Test. It will also
retain all configuration information stored in non-volatile memory by the copy
running-config startup-config command (See "copy" on page 4-84).
Default Setting
None
Command Mode
Privileged Exec
4-22