Configuring Lldp Interface Attributes; Figure 3-114 Lldp Configuration - SMC Networks 6128PL2 - annexe 2 Management Manual

Web – Click LLDP, Configuration. Enable LLDP, modify any of the timing parameters
as required, and click Apply.
CLI – This example sets several attributes which control basic LLDP message
timing.
Console(config)#lldp
Console(config)#lldp refresh-interval 60
Console(config)#lldp holdtime-multiplier 10
Console(config)#lldp tx-delay 10
Console(config)#lldp reinit-delay 10
Console(config)#lldp notification-interval 30
Console(config)#lldp medFastStartCount 6
Console(config)#exit
Console#show lldp config
LLDP Global Configuation
LLDP Enable
LLDP Transmit interval
LLDP Hold Time Multiplier
LLDP Delay Interval
LLDP Reinit Delay
LLDP Notification Interval : 30
. .
.

Configuring LLDP Interface Attributes

Use the LLDP Port/Trunk Configuration to specify the message attributes for
individual interfaces, including whether messages are transmitted, received, or both
transmitted and received, whether SNMP notifications are sent, and the type of
information advertised.
Command Attributes
• Admin Status – Enables LLDP message transmit and receive modes for LLDP
Protocol Data Units. (Options: Tx only, Rx only, TxRx, Disabled; Default: TxRx)
• SNMP Notification – Enables the transmission of SNMP trap notifications about
LLDP and LLDP-MED changes. (Default: Enabled)

Figure 3-114 LLDP Configuration

: Yes
: 60
: 10
: 10
: 10
Link Layer Discovery Protocol
3
4-248
4-250
4-248
4-251
4-251
4-249
4-249
3-191