SMC Networks 6128PL2 - annexe 2 Management Manual page 490

4
Command Line Interface
Default Setting
Disabled
Command Mode
Interface Configuration (Ethernet)
Command Usage
• The ports on both ends of an LACP trunk must be configured for full duplex,
and auto-negotiation.
• A trunk formed with another switch using LACP will automatically be assigned
the next available port-channel ID.
• If the target switch has also enabled LACP on the connected ports, the trunk
will be activated automatically.
• If more than eight ports attached to the same target switch have LACP
enabled, the additional ports will be placed in standby mode, and will only be
enabled if one of the active links fails.
Example
The following shows LACP enabled on ports 11-13. Because LACP has also been
enabled on the ports at the other end of the links, the show interfaces status
port-channel 1 command shows that Trunk 1 has been established.
Console(config)#interface ethernet 1/11
Console(config-if)#lacp
Console(config-if)#exit
Console(config)#interface ethernet 1/12
Console(config-if)#lacp
Console(config-if)#exit
Console(config)#interface ethernet 1/13
Console(config-if)#lacp
Console(config-if)#exit
Console(config)#exit
Console#show interfaces status port-channel 1
Information of Trunk 1
Basic information:
Port type:
Mac address:
Configuration:
Name:
Port admin:
Speed-duplex:
Capabilities:
Flow control status:
Port security:
Max MAC count:
Current status:
Created by:
Link status:
Operation speed-duplex: 100full
Flow control type:
Member Ports: Eth1/11, Eth1/12, Eth1/13,
Console#
4-182
100TX
00-12-CF-12-34-72
Up
Auto
10half, 10full, 100half, 100full
Disabled
Disabled
0
LACP
Up
None